Maintenance

Preventive maintenance:

The aim is to reduce the probability of equipment failures. We draw up a schedule with the customer depending on the imperatives of production, time and the number of units in use.

• INSPECTION: is carried out as part of a predetermined task and not limited to a comparison with pre-defined data;
• CONTROL: is checking conformity against predefined data;
• INSPECTION VISIT: consists of a predetermined detailed examination of the elements under contract;
• TESTING: is an operation to compare the response of a system to defined applied forces against a reference system (significant physical phenomena relating to correct operation).

Corrective maintenance:

This is linked to a predetermined event type: self-diagnosis, information from a sensor, wear measurements, etc. We monitor closely and intervene as soon as a defect appears, around the clock, under the terms of a contract.

• DETECTION: close surveillance of the equipment enables us to detect any defective element;
• LOCALISATION: as soon as a defect appears, we locate and isolate the cause of the problem detected;
• DIAGNOSIS: identification of the cause is defined by a set of information from normal inspection of the equipment, testing or control;
• REPAIR: we intervene 24h/24 under contract and carry out repairs on site or in our workshops if necessary.

Levels of maintenance